Aade:

-MHW-

- Solucin al BUG, que impeda la sintonizacin de otro canal, despus de asignar una clave DCW a un canal. (era necesario reiniciar el decodificador).

- Control del posible error de sintonizacin en el arranque del Jungle.

- Compatibilidad en el mostrado del nombre del canal, cuando es menor a 3 letras.

- Estabilizacin de la duracin y contenido del banner del canal en el arranque y en cambios rpidos de canales.

- Incorporado ajuste personalizado del tiempo de espera entre cada paquete de transmisin rs-232, que es usado durante la realizacin de la lectura de la flash desde el Mediacom.

Podemos seleccionar desde 0 hasta 300 Ms. en incrementos de 10 en 10 Ms., siendo 0 el valor por omisin.

Se ajusta desde la pantalla "+,B,9", pulsando repetidamente el "3". No es necesario reiniciar el decodificador ni la conexin rs-232 para que este cambio surja efecto.

Procedimiento: Si vemos que en el procedimiento explicado en la v23 con las paulatinas reducciones del buffer no van mejorando el resultado, dejamos el tamao del buffer en el valor que funcione mejor y vamos haciendo pruebas aumentando paulatinamente el tiempo de espera hasta que se consiga un dump completo.

Por ejemplo, para un ordenador especialmente negado a realizar el dump de la lista de canales, ha sido necesario seleccionar un Tx Buffer de 128 bytes y un Tx Pause de 100 Ms., con ello ya es capaz de leer incluso todo el firmware completo sin errores, pero eso s, tardando 10 veces ms que con los valores por omisin.

- Optimizacin del cdigo.




Atencin: Con Jungle gOLDbox desde la v.17 correctamente cargado en el decoder no es necesario borrar eeprom, en los dems casos es necesario borrar eeprom.



JungleTEAM


Add:

-MHW-

- Increased MHW / EMU synchronization, in the channel change.

- Fixed the bug that prevented another channel tuning, after allocating or de-assign a key to a channel DCW. (it was necessary to restart the decoder).

- Control of possible tuning error in the Jungle boot.

- Support in the channel name shown when less than 3 letters.

- Stabilization of the timing and content of the channel banner at startup and rapidly changing channels.

- Built custom fit the waiting time between each packet transmission rs-232, which is used during the course of reading the flash from Mediacom.

You can select from 0 to 300 Ms. of 10 in 10 Ms. increments, where 0 value is the default.

Fits from the "+, B, 9" by repeatedly pressing the "3". No need to restart the decoder and the RS-232 connection for this change to take effect.

Procedure: If we see that the procedure explained in v23 with gradual reductions in the buffer will not improve the outcome, let the buffer size on the value that works better and we are doing tests gradually increasing the waiting time until you get a full dump.
For example, for a particular computer refused to do the dump of the channel list has been necessary to select a Tx buffer of 128 bytes and a Tx Pause 100 Ms., and is thus able to read even the entire firmware is complete without errors, but yes, taking 10 times more than the default.

- Code optimization.

Attention: from Jungle gOLDbox v.17 properly loaded in the decoder does not need to erase eeprom, in other cases it is necessary to erase eeprom.